A. facial precautions:
1.Do not loosen the skin. (such as genuine leather: toe, toe cover and outer waist, do not appear defective leather, such as insect spots, scratches, hemp spots).
2.Do not hair the toe, the back of the bag should be straight. The height of the waist must be strictly accurate.
3.Do not have floating line, broken line, more do not have no bottom line, jump needle.
4. Whether the ratio of toe tip warping is consistent or not, and whether the comparison is correct or not.
5.Do not crease the inside of the toe tip or make the foot, check whether to climb into the middle sole (consider putting the front port after the cotton shoes to help the front half of the foot car line).
6. Comparing with the sample shoes, whether the vamp is chromatic aberration, whether the brightness and polishing effect are the same as the sample.
7.Do not allow the shoe barrel to be unfitted or crumpled, the zipper to be smooth and the lock position to be firm.
8.Eye fastness is enough (men’s shoes with shoelaces), the position should not have obvious penetration marks, do not hit the foot.
9. Check if there is any drawing under the middle bottom plate, if there is any missing or missing port, or if the port is not hard enough (especially after port must be hard).
10.Check whether the trademark letter class is correct, indispensable letters.
11.No nails in it, no delamination, no wrinkling. The color of the leather should be dyed thoroughly, and the cutting edge should be of the same color.
12 upper toe position, back bag position can not appear, uniform line, can not jump line.
13.Men’s shoes should have eyelet buttons, lining shoes should be aligned, no rough edges, and punching holes should be smooth.
14. leather work shoes of various parts of leather to use, with a pair of to be sure.
15. Whether the port is pulled into the bottom plate. Whether the foot is soft
B. notes for bottom:
1 adhesive force, whether can reach the standard, because the male shoe sole adhesion, such as: with the hand to move in a certain situation does not open the glue, the other two waist can not be short of glue, glue line should be controlled within the scope, especially light color shoes.
2 all male footwear outsole to smooth, can not have steel core penetration marks, outsole can not have concave and convex and front and rear kick phenomenon.
3 the outsole can not be kicked back and forth, the toe head should be positive, the SIZE of the side and outsole must be correct.
4 big bottom, can not fade color, thickness. Soft and hard to reach the standard.
5 the bottom of the strip need to fit in place, there are wrap edge can not take edge, must be smooth, can not open the glue, the glue.
6 The treatment after the outsole must refer to the standard, not under the standard scope.
7 Middle sole, hot sole is rolled edge, insole is stuck firmly.
8. Check whether the middle bottom is made of hard steel and is resistant to bending. Check whether the material meets the company’s requirements.
C. Solidity precautions
1. Whether the tensile force and abrasion resistance of materials have passed.
2. Whether the finished product has passed the cold resistance tortuous test or not.
3 shoe tongue. Woven belt. After the belt and other parts by the tension of parts to reach the standard.